Pump M50
This Rheinstrom bilge pump is the ultimate choice in any way. Highest pump performance at almost no signs from wearing during operation – practically clogging-free – real fast to clean. A long handy hand lever makes an easy operation possible even over a longer period of time. Big connections and the special design protect it against clogging. Even foreign matters such as rags can be transported though. Easy cleaning, fast maintenance – after opening the inspection lid there is a direct access to the valves. Design: The pump body has been cast with an aluminium alloy. After the mechanical finishing it gets a hard-wearing coat. Valves and diaphragms are made of neoprene. All screws are made of stainless steel. Installation: There are uncountable ways of installation and mounting (foot mounting and rear mounting). By turning the top about 180° the discharge and suction side is changed (intermediary stages every 45°). The pump lever can also be mounted on the opposite side. Note: The cable cross section must not be smaller than 1 1/2 "(38 mm) be. Otherwise you will not reach the specified pump capacity.